Viewing 6 posts - 1 through 6 (of 6 total)
  • Author
    Posts
  • #6491
    Chiang Nickchiang nick
    Participant

    I would like to ask because the simulated values of my water level and water temperature are higher than the measured values.
    Which parameters need to be adjusted to improve the simulation results?
    I am looking forward to your answer. Thank you very much!

    #6495
    Chiang Nickchiang nick
    Participant

    Like this file

    Attachments:
    You must be logged in to view attached files.
    #6497
    Chiang Nickchiang nick
    Participant

    and this water temperature file

    Attachments:
    You must be logged in to view attached files.
    #6572
    EEMS TeamEEMS Team
    Keymaster

    The water levels here are unusual. We would need to see the model to determine the issue. You can upload it here or send to [email protected] and someone will try to have a look at it if time permits.

    #6580
    Chiang Nickchiang nick
    Participant

    Here is the model.Hope we can find the ways to improve the simulation.
    Do you need the observed water level data?

    #6588
    EEMS TeamEEMS Team
    Keymaster

    We looked at your model and see that there is an issue with the water balance, which explains the rising water levels. See the image below.

    Attachments:
    You must be logged in to view attached files.
Viewing 6 posts - 1 through 6 (of 6 total)
  • You must be logged in to reply to this topic.